Lambretta Workshop All*

Spark Plug Long Reach Available in grades 6, 7, 8, 9. (Nine Coldest Running) B6ES, B7ES, B8ES, B9ES

Spark Plug Cap with .6 meter of Black HT Lead and HT Coil rubber boot. Good Secure Snap On Connection to the Spark Plug. If this item is out of st...

Spark Plug Long Reach Available in Grades 6, 7, 8, 9, 10. (Nine coldest running) BR6ES, BR7ES, BR8ES, BR9ES, BR10ES

Oil Measure Jug 100ml   Same as Original Part No. 085058

Bulb - Headlight - BA20D Bosch Fitting 12 Volts, 35/35 Watts Ex Part Number: BLB089

STEERING NUT RING SPANNER     Made from 304L Stainless steel, will last a lifetime.

Beedspeed Timing Disc in Degree's with Timing Instructions Alloy Disc 16.3cm Diameter with 1.3cm Centre Hole . Link to Lambretta and Vespa Ti...

Tool - Cable Puller - With Thumb Lock Pulls Cables and Slides NippleThird Hand Suitable for all cables As used on the following, Auto scooters Mot...

1Meter of HT lead   

STEERING NUT C SPANNER 37mm

Spark Plug Cap - Resistor Cover LB05F Sizes dimensions below.

Lambretta Clutch Holding Tool Sits on the Lambretta clutch spider with the handle between the spaces in the crown wheel... locking the clutch spide...

Lambretta Engine Mounting Removal and Fitting Tool E (J3-K8)

Tool - Oil Measure Jug And Cap 100mls B (J3-C6)

Lambretta Rear Hub Puller For Series 3 3 Hole, 7mm Bolts C (J3-J10)

Universal Con Rod Holding Tool, suitable for Lambrettas and Vespas.Laser cut from 304L Stainless Steel, will last forever!

Lambretta - Rear Hub Nut - Chrome M16 Large Hex Original Shape

Lambretta Rear Hub Puller - Heavy Duty For Series 3 3 Hole, 7mm Bolts D (J3-K7)

Tool - Inner Tube Puncture Repair Kit As pictured, supplied in small green case.

Tool - Lambretta Fork Spring and Rear Shock Compressor E (J3-L7)

TUBELESS TYRE PUNCTURE REPAIR KIT Kit Consists of: 1x Carry Case 1x Probe 1x Eye Needle 1x Rubber Cement 1x Knife 5x Strip Plugs - Enou...

Fork Oil Syringe - Capacity 60ml B (J3-C5)

SPRING PULLING HOOK HEAVY DUTY - Stainless Steel Suitable for Stand / Exhaust Springs etc. 8 Inch / 20cm Long

Bulb - Festoon - 6V 5W - 38mm x 10mm

Lambretta Scooter Cover - All Models The scooter cover is a waterproof fabric design, unlike many cheaper covers which are only a plastic sheet an...

Tool - Lambretta Front Fork Link Bush And Buffer Drift D (J3-J3)

Tool - Piston Pin Removal Tool - 16mm - Lambretta & Vespa P200/T5

Tool - Lambretta Crankcase Separator Splitter

Petro Patch Putty - Granville - Heavy Duty - 50gram Granville Petro Patch Putty is a fast acting Epoxy Putty with hundreds of uses around the auto...

Lambretta Rear Jack to Replace Spare Wheel B (J3-L10)

Lambretta Flywheel Holding Tool E (J3-L11)

Bulb - Festoon - 12V 5W - 38mm x 10mm

Tool - Lambretta Gear Cluster Bush Extractor/Puller C (J3-J6)

Lambretta Flywheel Extractor ( Double Ended, All Models Italian, Spanish, Indian.) 27mm x 1.25mm pitch and 30mm x 1.5mm pitch. Heavy Duty